Impianti compatti

Per motivi di sicurezza di esercizio, negli impianti per il trattamento delle acque di scarico il primo passo consiste sempre nella separazione meccanica delle acque.

In questa fase di processo vengono effettuate

  • grigliatura fine delle acque di scarico
  • trattamento grigliato
  • separazione sabbie
  • classificazione sabbie
  • separazione ed asporto grassi

in modo da prevenire anomalie di funzionamento (intrecciamenti, usura, accumulo di sabbia...).

Avanti...Chiusura

A metà degli anni ottanta, questi complessi compiti sono stati per la prima volta riuniti tutti in un impianto di pretrattamento compatto ROTAMAT®. Da allora questi impianti sono stati continuamente sviluppati ed arricchiti di numerose varianti e misure costruttive – tutte adattate in modo ottimale alle particolari esigenze del singolo utente.

Prodotti

Downloads

Dettagli

Dettagli

1. Fine screening

Depending on the specific conditions and data, such as peak flow, screenings load and grit load, one of the following screens is selected:

2. Screenings treatment

  • All ROTAMAT® Screens above include a screenings press. Screenings washing with (optional) dewatering and compaction. Solids concentration of screenings is up to 45 % DS.
  • For our STEP SCREEN® SSF and Belt Screen EscaMax® a separate HUBER Screenings Wash Press WAP® is usually installed behind. Solids concentration of screenings, depending on the WAP type used is up to 50 % DS.

3. Grit separation
The grit channels of our ROTAMAT® Complete Plants are designed in accordance with international standards or the customer's specific requirements. The grit channels are availabe as aerated or optionally unaerated units. The selection of the grit channel type (aerated or unaerated) depends on various criteria, such as the storm/dry weather flow ratio or whether further grit treatment systems are planned.

4. Grit removal and discharge
The settled grit is collected from the bottom of the grit channel with a horizontal grit screw. An inclined grit screw conveys, agitates and dewaters the collected grit. The classified grit slides from the upper end of the inclined screw into a RoSF 4/t Grit Washer.

5. Grease separation and removal (optional)
Separation of fats and grease is only available when used with aerated grit channels. The grease is collected in a separate chamber with the partition between the grit trap chamber and grease chamber consisting of a slotted scum board. In contrast to many competitors, the floating fats and oils are skimmed off the water surface with a paddle scraper that is slowly pulled with a stainless steel rope. The paddle is shaped so that it removes virtually all floating matter from the grease trap. Anaerobic degradation of fat and grease, and therewith odor nuisance, is thus prevented.